CGR 4th Class 4-6-0TT 1880
South African Class 04 4-6-0TT 1880
No. E29 on a passenger train, c. 1886
Type and origin
Power typeSteam
DesignerCape Government Railways
(Michael Stephens)
BuilderRobert Stephenson and Company
Serial number2361-2366, 2385-2390, 2431-2436
Build date1879-1880
Total produced18
Specifications
Configuration:
​
 • Whyte4-6-0TT (Tenwheeler)
 • UIC2'Cn2t
Driver2nd coupled axle
Gauge3 ft 6 in (1,067 mm) Cape gauge
Leading dia.27+1⁄2 in (698 mm)
Coupled dia.Eastern: 38 in (965 mm)
Midland: 42 in (1,067 mm)
Tender wheels36 in (914 mm)
Wheelbase35 ft 2+7⁄8 in (10,741 mm) ​
 • Engine17 ft (5,182 mm)
 • Leading5 ft (1,524 mm)
 • Coupled8 ft (2,438 mm)
 • Tender8 ft (2,438 mm)
Length:
​
 • Over couplers43 ft 4+7⁄8 in (13,230 mm)
HeightEastern: 12 ft 1 in (3,683 mm)
Midland: 12 ft (3,658 mm)
Axle load8 LT 14 cwt (8,840 kg) ​
 • Leading8 LT 16 cwt (8,941 kg)
 • 1st coupled7 LT 13 cwt (7,773 kg)
 • 2nd coupled8 LT 14 cwt (8,840 kg)
 • 3rd coupled7 LT 11 cwt (7,671 kg)
 • Tender axleAxle 1: 8 LT 14 cwt (8,840 kg)
Axle 2: 6 LT 17 cwt (6,960 kg)
Axle 3: 7 LT 11 cwt (7,671 kg)
Adhesive weight23 LT 18 cwt (24,280 kg)
Loco weight32 LT 14 cwt (33,220 kg)
Tender weight23 LT 2 cwt (23,470 kg)
Total weight55 LT 16 cwt (56,700 kg)
Tender type3-axle
Fuel typeCoal
Fuel capacity6 LT (6.1 t)
Water cap.600 imp gal (2,730 L) engine
Tender cap.1,675 imp gal (7,610 L)
Firebox:​
 • TypeRound-top
 • Grate areaRegular: 11.7 sq ft (1.09 m2)
Tilney: 10.9 sq ft (1.01 m2)
Boiler:
​
 • PitchEastern: 5 ft 9 in (1,753 mm)
Midland: 5 ft 11 in (1,803 mm)
 • Diameter3 ft 6 in (1,067 mm) inside
4 ft 2 in (1,270 mm) outside
 • Tube plates10 ft 1 in (3,073 mm)
 • Small tubes145: 1+3⁄4 in (44 mm)
Boiler pressure140 psi (965 kPa)
Safety valveSalter
Heating surface753 sq ft (70.0 m2) ​
 • Tubes688 sq ft (63.9 m2)
 • Firebox65 sq ft (6.0 m2)
CylindersTwo
Cylinder size15 in (381 mm) bore
20 in (508 mm) stroke
Valve gearStephenson
CouplersJohnston link-and-pin
Performance figures
Tractive effort11,250 lbf (50.0 kN) @ 75%
Career
OperatorsCape Government Railways
South African Railways
ClassCGR 4th Class, SAR Class 04
Number in class18
NumbersM34-M39, M50-M55, E27-E32
Delivered1880-1881
First run1880

The Cape Government Railways 4th Class 4-6-0TT of 1880 was a South African steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1880 and 1881, the Cape Government Railways placed eighteen 4th Class 4-6-0 tank-and-tender locomotives in mainline service on its Midland and Eastern Systems, working out of Port Elizabeth and East London respectively. It was the first South African locomotive to be built to a local design. Four of these locomotives were still in service to come onto the South African Railways roster in 1912.[1]

Manufacturer

Increasing traffic and heavier loads on the Cape Government Railways (CGR) lines into the interior from Port Elizabeth on the Midland System and East London on the Eastern System, led to a requirement for larger and more powerful locomotives by the late 1870s.[1]

Michael Stephens

The 4th Class 4-6-0 tank-and-tender locomotive was designed by Michael Stephens, at that stage the Locomotive Superintendent of the Western System in Cape Town, and six locomotives were ordered from Robert Stephenson and Company in 1879. This was the first South African locomotive to be built to a local design, prepared in the CGR drawing office in Salt River. These were delivered to the Midland System in 1880, numbered in the range from M34 to M39.[1][2]

They were followed by two more batches of six from the same manufacturer. The second batch was delivered to the Eastern System in 1880 and 1881, numbered in the range from E27 to E32, and the last batch to the Midland System in 1881, numbered in the range from M50 to M55.[2]

Characteristics

These locomotives, which used Stephenson valve gear, were intended for freight work. The locomotives delivered to the Midland System had coupled wheels of 42 inches (1,067 millimetres) diameter, while those delivered to the Eastern System where grades were much more severe, had coupled wheels of 38 inches (965 millimetres) diameter.[3][4]

All the locomotives were delivered with optional three-axle tenders and, depending on the task at hand and the distance involved, could be used in either the tank engine or the tank-and-tender configuration. To facilitate easy uncoupling from the tender and direct coupling to rolling stock while working as a tank engine, the engine-to-tender couplings were Johnston link-and-pin couplers instead of the more usual drawbar. Each side of the cab was equipped with a side entrance and double handrails to allow easy access or egress to the crew while working without a tender.[1][4]

These locomotives were the first in South Africa to be equipped with compensated spring gear on all coupled wheels. Their coupling rods extended from crank-pin to crank-pin, with no knuckle joints. The 5 feet (1,524 millimetres) wheelbase bogie had a lateral traverse of 1+1⁄4 inches (32 millimetres) to each side, which was restrained by two cylindrically-shaped rubber cushion pads, each 5+5⁄8 inches (143 millimetres) in diameter and 5 inches (127 millimetres) deep. Two inverted laminated springs carried the vertical load.[4]

Since the engine did not have a coal bunker, photographs of a locomotive working in the tank engine configuration will sometimes show the engine with a bag of coal slung onto the side tanks or stowed on the running boards. These locomotives retained their side-tanks throughout their working lives.[1]

Modifications

J.D. Tilney

J.D. Tilney, the Eastern System's Locomotive Superintendent, carried out several experiments on some of these 4th Class locomotives. One of the modifications introduced by Tilney was an extended smokebox to make room for a very efficient spark arrester, constructed of wire mesh. In 1882, he reported that grass fires caused by locomotives had been rarely known since the spark-arresters were installed. Several locomotives on the Eastern and Midland Systems were altered to incorporate these spark arresters.[1][4]

Another modification involved modifying the boiler and frame to accommodate oscillating firebars and a larger firebox to overcome the problems associated with the low-grade local coal from the Cyphergat collieries. Mechanical firegrate shaking was accomplished by means of a collar on the leading coupled axle which could be engaged by a roller with eccentrically mounted connecting rods to the oscillating firebars. The drawings to illustrate the operation of the oscillating firebars were published in Mechanical Engineers in 1890.[1][5]

Service

Cape Government Railways

At the time the 4th Class entered service, the Eastern System's lines were open to King William's Town and approaching Queenstown, with the latter being opened on 5 May 1880. The Midland System's lines were completed to Graaff Reinet and Cookhouse respectively.[6]

During their service lives on the CGR, all these locomotives were renumbered more than once. By 1886, the system prefixes had been done away with and the Midland System's locomotives had all been renumbered by replacing the letter prefix "M" with the numeral "1". By 1888, the six Eastern System locomotives had been renumbered into the 600 number range. The Midland System locomotives were renumbered twice more, into the 200 number range by 1890 and into the 400 number range by 1899.[1][2]

By 1899, the first batch of six locomotives of the Midland System was no longer reflected in the locomotive register. By 1904, all six of the Eastern System were gone from the register as well.[1][2]

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and Central South African Railways) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways was only implemented with effect from 1 January 1912.[6][7]

By 1912, four locomotives survived, numbers 451 to 454. They were considered obsolete by the SAR, designated Class 04 and renumbered by having the numeral "0" prefixed to their existing numbers.[7]

Works numbers

The works numbers, years built, original numbers and renumbering of the Cape 4th Class of 1880 are listed in the table.[1][2][7]

Illustration

The photograph illustrates a modified locomotive with an extended smokebox, working without its tender. Note the coal bag on the side tank.

References

Wikimedia Commons has media related to CGR 4th Class 4-6-0TT 1880.
  1. ^ a b c d e f g h i j Holland, D.F. (1971). Steam Locomotives of the South African Railways. Vol. 1: 1859–1910 (1st ed.). Newton Abbott, England: David & Charles. pp. 32–34. ISBN 978-0-7153-5382-0.
  2. ^ a b c d e C.G.R. Numbering Revised, Article by Dave Littley, SA Rail May–June 1993, pp. 94-95.
  3. ^ Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Adoption of the 3 ft. 6 in. Gauge on the Cape Government Railways. South African Railways and Harbours Magazine, July 1943. pp. 515-518.
  4. ^ a b c d Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Cape Government Railways (Continued). South African Railways and Harbours Magazine, October 1943. pp. 731-734.
  5. ^ Coal Burning on Cape Railways, Mechanical Engineers 1890, Plates 33 and 34.
  6. ^ a b The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, pp. 12, 25.
  7. ^ a b c Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer's Office, Pretoria, January 1912, pp. 26-27. (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
Categories