This article includes a list of general references, but it lacks sufficient corresponding inline citations. Please help to improve this article by introducing more precise citations. (September 2010) (Learn how and when to remove this template message)
Paper clip mold opened in molding machine; the nozzle is visible at right
Paper clip mold opened in molding machine; the nozzle is visible at right
A 1300-ton injection molding machine with robotic arm
A 1300-ton injection molding machine with robotic arm

An injection molding machine (also spelled as injection moulding machine in BrE), also known as an injection press, is a machine for manufacturing plastic products by the injection molding process. It consists of two main parts, an injection unit and a clamping unit.

Operation

Injection moulding machine moulds can be fastened in either a horizontal or vertical position. Most machines are horizontally oriented, but vertical machines are used in some niche applications such as insert moulding, allowing the machine to take advantage of gravity. Some vertical machines also do not require the mould to be fastened. There are many ways to fasten the tools to the platens, The most common are manual clamps (both halves are bolted to the platens); however, hydraulic clamps (chocks are used to hold the tool in place) and magnetic clamps are also used. The magnetic and hydraulic clamps are used where fast tool changes are required.

The person designing the mould chooses whether the mould uses a cold runner system or a hot runner system to carry the plastic and fillers from the injection unit to the cavities. A cold runner is a simple channel carved into the mold. The plastic that fills the cold runner cools as the part cools and is then ejected with the part as a sprue. A hot runner system is more complicated, often using cartridge heaters to keep the plastic in the runners hot as the part cools. After the part is ejected, the plastic remaining in a hot runner is injected into the next part.

Types of injection molding machines

Machines are classified primarily by the type of driving systems they use: hydraulic, mechanical, electrical, or hybrid

Hydraulic

Hydraulic process have historically been the only option available to molders until [[]] introduced the first all-electric injection molding machine in 1983. Hydraulic machines, although not nearly as precise, are the predominant type in most of the world, with the exception of Japan.[citation needed]

Mechanical

Mechanical type machines use the toggle system for building up tonnage on the clamp side of the machine. Tonnage is required on all machines so that the clamp side of the machine does not open (i.e. tool half mounted on the platen) due to the injection pressure. If the tool half opens up, it will create flash in the plastic product.

Electric

The electric press, also known as Electric Machine Technology (EMT), reduces operation costs by cutting energy consumption and also addresses some of the environmental concerns surrounding the hydraulic press. Electric presses have been shown to be quieter, faster, and have a higher accuracy, however the machines are more expensive.

Hybrid injection (sometimes referred to as "Servo-Hydraulic") molding machines claim to take advantage of the best features of both hydraulic and electric systems, but in actuality use almost the same amount of electricity to operate as an electric injection molding machine depending on the manufacturer.[1][2]

A robotic arm is often used to remove the molded components; either by side or top entry, but it is more common for parts to drop out of the mold, through a chute and into a container..

Main components of injection molding machine

Injection unit

Consists of three main components:

  1. Screw motor drive
  2. Reciprocating screw and barrel
  3. Heaters, Thermocouple, Ring plunger

Clamping unit

Consists of three main components:

  1. Mold
  2. Clamping motor drive
  3. Tie bars, the sender is clamped onto the edge of a workbench

References

  1. ^ "Choose a Login Method" (PDF). oaktrust.library.tamu.edu.
  2. ^ "FNX-III Series". www.nisseiamerica.com.

Further reading