Family of small, low-horsepower, four-cylinder, air-cooled engines
The Lycoming O-145 is a family of small, low-horsepower, four-cylinder, air-cooled engines. It was Lycoming Engines' first horizontally opposed aircraft engine and was produced from 1938 until the late 1940s. The family includes the reduction-geared GO-145.[1][2][3] The O-145 received its Approved Type Certificate on 13 Jun 1938.
Design and development
The O-145 was produced in three major versions, the O-145-A rated at 55 hp (41 kW), the -B rated at 65 hp (48 kW), and -C rated at 75 hp (56 kW). The "B" model was the major production model, with the "A" and "C" produced in much smaller quantities.[1][2]
All models of the series had the same bore, stroke, and displacement, additional horsepower being generated by increasing compression ratio and maximum rpm. All use a Stromberg NA-S2 or NA-S2A or Marvel MA-2 or MA-2-A carburetor. The dual ignition versions use two Scintilla SF-4L, SN4LN-20 or -21, Superior SMA-4 or Edison-Splitdorf RMA-4 magnetos.[1][2]
The original O-145-A produced 55 hp (41 kW) at 2300 rpm, weighed 165.5 lb (75 kg), and featured single ignition. In an attempt to compete with the Continental A-65, Lycoming boosted the rpm and power output to 65 hp (48 kW) at 2550 rpm, and finally 75 hp (56 kW) at 3100 rpm. The O-145 had a hard time competing with the same horsepower Continentals due to its smaller displacement, which resulted in a steeper torque curve.[1][3]
The GO-145 is a geared model, introduced in 1938, that uses a 27:17 reduction ratio (1.59:1) gearbox to produce 75 hp (56 kW) at 3200 crankshaft rpm, giving 2013 propeller rpm. The engine employs a gearbox bolted to the front of the engine and the resulting engine weighs 193 lb (88 kg) without starter or generator. The GO-145 suffered from a poor reputation for reliability, because pilots mis-handled the engine, running it at too low a cruising rpm and causing gearbox wear as a result.[1][2][3][4]
The series' type certificate expired on 2 November 1950 and no O-145-B1 or -C1 or GO-145-C1s engines produced after 1 August 1941 and O-145-B2, -B3 or -C2, or GO-145-C2 or -C3s produced after 24 August 1949 are eligible for certification. The single ignition O-145-A series, O-145-B1, and -C1 are not covered by the original type certificate.[1]
Lycoming ended production of the O-145 and replaced it with the O-235 series.[3]
Specifications (GO-145-C2)
Data from Type Certificate 210[1]
General characteristics
Components
- Fuel system: Stromberg NA-S2 or NA-S2A or Marvel MA-2 or MA-2-A carburetor
- Fuel type: minimum 73 octane
- Cooling system: air-cooled
Performance
.jpg)
