This article needs additional citations for verification. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed.Find sources: "Padeye" – news · newspapers · books · scholar · JSTOR (September 2013) (Learn how and when to remove this template message)
An Aviation Machinist's Mate connecting tiedown chains to padeyes on the flight deck of the aircraft carrier USS Dwight D. Eisenhower (CVN 69)

A padeye is a device often found on boats or ships that a line runs through or provides an attachment point. It is a kind of fairlead and often is bolted or welded to the deck or hull.

It is also used in oil and gas projects to assist in the purpose of lifting.

Detail

It is made of steel plate with radius at one side. Lifting is done with the help of a D-shackle or sling, which fits into the hole of the padeye. There may be one or more circular plates (cheek plates) welded around the hole.

Designing

The following check should be done for the design of padeyes and to keep the stress less than the allowable stresses:

At the hole:

  1. Bearing stress
  2. Shear stress
  3. Tensile stress
  4. Hertz bearing stress

At the base

  1. Shear stress
  2. Tensile stress
  3. Bending stress
  4. Combined bending stress and tensile stress
  5. Von-Mises stress[1]

Analysis on a padeye is commonly performed in accordance with the Air Force Stress Analysis Manual[2] or ASME BTH-1.[3] The methodology in ASME BTH-1 only allows for axially loaded lugs, whereas the methodology in the Air Force Stress Analysis Manual allows for axial loading, transverse loading, or oblique (combined) loading.[4]

Failure modes

Tests have confirmed that there are four potential failure modes for a lug plate:

  1. Tension failure at the sides of the hole
  2. Crushing above the lifting pin followed by tearing tension fracture at the plate edge
  3. Shear failure in the lug plate as the lifting pin attempts to plow its way towards the edge of the free plate
  4. Dishing (out-of-plane buckling) failure of relatively thin lug plates that are laterally unrestrained

References

  1. ^ http://e-book.lib.sjtu.edu.cn/otc-2007/pdfs/otc19040.pdf[permanent dead link]
  2. ^ ""Stress Analysis Manual," Air Force Flight Dynamics Laboratory, October 1986" (PDF). Archived from the original (PDF) on November 15, 2016.
  3. ^ "ASME BTH-1, "Design of Below-the-Hook Lifting Devices," The American Society of Mechanical Engineers, 2014".
  4. ^ "Padeye/Lug Analysis".
Category