USS Thresher (SSN-593)
Class overview
Builders	Portsmouth Naval Shipyard Mare Island Naval Shipyard Ingalls Shipbuilding New York Shipbuilding General Dynamics Electric Boat
Operators	United States Navy
Preceded by	Skipjack class
Succeeded by	Sturgeon class
Built	1958–1967
In commission	1961–1996
Completed	14
Lost	1
Retired	13
General characteristics
Type	Nuclear submarine
Displacement	3,750 long tons (3,810 t) surfaced 4,300 long tons (4,369 t) submerged[1]
Length	278 ft 5 in (84.86 m)
Beam	31 ft 7 in (9.63 m)
Draft	25 ft 2 in (7.67 m)
Propulsion	1 S5W PWR 2 steam turbines, 15,000 shp (11 MW) 1 shaft
Speed	15 knots (28 km/h; 17 mph) surfaced 28 knots (52 km/h; 32 mph) submerged
Range	Unlimited, except by food supplies
Test depth	1,300 ft (400 m)
Complement	112
Sensors and processing systems	BQQ-2 sonar (later BQQ-5) Mark 113 Fire-control system (later Mark 117) Periscopes
Electronic warfare & decoys	ESM
Armament	4 × 21 inch (533 mm) torpedo tubes amidships 12-18 × Mark 37 torpedoes, later replaced by Mark 48s 4-6 × UUM-44 SUBROC anti-submarine missiles 4 × UGM-84 Harpoon anti-ship missiles

The Permit-class submarine (known as the Thresher class until the lead boat USS Thresher was lost) was a class of nuclear-powered fast attack submarines (hull classification symbol SSN) in service with the United States Navy from the early 1960s until 1996. They were a significant improvement on the Skipjack class, with greatly improved sonar, diving depth, and silencing.^[1] They were the forerunners of all subsequent US Navy SSN designs. They served from the 1960s through to the early 1990s, when they were decommissioned due to age.^[2] They were followed by the Sturgeon and Los Angeles classes.

The Thresher class was one of several results from a study commissioned in 1956 by Chief of Naval Operations (CNO) Admiral Arleigh Burke. In "Project Nobska", the Committee on Undersea Warfare of the United States National Academy of Sciences, collaborating with numerous other agencies, considered the lessons of submarine warfare and anti-submarine warfare learned from various prototypes and experimental platforms. The design was managed under project SCB 188.^[3]

Design

The new class kept the proven S5W reactor plant from the immediately preceding Skipjacks, but were a radical change in many other ways. The Threshers had the large bow-mounted sonar sphere and angled, amidships torpedo tubes used in the concurrently-built Tullibee. This placed the sonar sphere in the optimum position for detection of targets at long range. Tullibee was an alternate design optimized for anti-submarine warfare, much smaller and slower than the Threshers and with a quiet turbo-electric propulsion system.^[4] Although they used the same HY-80 steel (yield strength 80,000 psi (550 MPa)) as the Skipjacks, the Threshers' pressure hulls were made using an improved design that extended test depth to 1,300 ft (400 m). The engineering spaces were also redesigned, with the turbines supported on "rafts" that were suspended from the hull on isolation mounts for acoustic quieting. Drag was reduced, with external fittings kept to a minimum and the sail greatly reduced in size.^[1]

The small sail of Thresher (the smallest fitted to an American SSN) compensated for the increased drag of the longer hull, giving Thresher a top speed of 33 knots (61 km/h; 38 mph), the same as the Skipjacks, according to one recollection.^[5] However, the small sail had disadvantages as well, including room for only one periscope and a reduced number of electronics masts, less convenient surfaced operation in rough seas, and an increased possibility of "broaching" (inadvertent surfacing) at periscope depth in rough seas.^[6]

Only Thresher was fitted with a five-bladed symmetric screw, very similar to the ones originally fitted to the Skipjacks, which allowed her to reach this speed. During trials of the Skipjack class, it was found that the propeller produced noise below cavitation depth. It was determined that the source of this noise, called blade-rate, was the blades of the screw vibrating when they hit the wake of the sail and control surfaces.^[1] This produced a noise that could carry for many miles and could be used by an enemy submarine to set up a firing solution because the frequency of blade-rate was directly related to the speed of the submarine (the RPM of the screw). The solution was to either make the screw smaller so it did not hit the wakes of the sail and control surfaces, which would cavitate more easily because of its increased speed, or have a large screw that gently interacted with these areas of disturbed water. The latter solution was chosen for all subsequent American SSNs. Permit and later submarines of this class had seven-bladed skewback screws, which reduced the problem of blade-rate, but reduced the submarines' top speed to 29–28 knots (54–52 km/h; 33–32 mph). Jack was designed with counter-rotating screws, each of which were smaller than the standard seven-bladed screw, as an alternative solution to the blade-rate problem.^[1]

The class received mid-life upgrades in the late 1970s and 1980s, including the AN/BQQ-5 [uk] sonar suite with a retractable towed array, Mk 117 torpedo fire control equipment, and other electronics upgrades.^{[citation needed]}

Armament

The boats had their torpedo tubes moved to the middle of the hull and angled outboard. This made available the required large space in the bow for the BQQ-2 (BQQ-5 as modernized from the late 1970s) sonar sphere, a new and powerful low-frequency detection sensor. Initially armed with Mark 37 torpedoes, by the late 1960s they carried the improved Mark 48 and the nuclear UUM-44 SUBROC short-range anti-submarine missile, replacing up to six Mk 48s. The Threshers were the first class fitted with the Mark 113 fire control system that enabled the use of SUBROC; they were later upgraded with the Mark 117 system. In the late 1970s the UGM-84 Harpoon anti-ship missile was introduced; typically four were carried in place of Mk 48s.^{[citation needed]}

The maximum weapons load was 23 torpedoes/missiles or, theoretically, up to 42 Mk 57, Mk 60, or Mk 67 mines. Any mix of mines, torpedoes, and missiles could be included.^[7]

Construction

The first submarine commissioned in the class was the ill-fated Thresher, and so the class was known by her name. When Thresher was lost on 10 April 1963, the class took the name of the second ship in the class, Permit. Thresher had numerous advanced design features and embodied the future of US Navy submarine design, and her loss was a serious blow. As a result, the SUBSAFE program was instituted to correct design flaws and introduce strict manufacturing and construction quality control in critical systems. The seawater and main ballast systems of future classes (Sturgeon-class SSNs and Benjamin Franklin-class SSBNs) were redesigned, and some Threshers and other submarines were rebuilt to SUBSAFE standards. SUBSAFE includes specific training of SUBSAFE quality assurance inspectors in the engineering crew, and tracks extremely detailed information about every component of a submarine that is subject to sea pressure. Joints in any equipment carrying seawater must be welded (not brazed), and every hull penetration larger than a specified size can be quickly shut by a remote hydraulic mechanism.^[6] The program has been very successful, as no SUBSAFE submarines have been lost as of 2023 (Scorpion was not SUBSAFE).^{[citation needed]}

Flasher, Greenling, and Gato were designed under project SCB 188M and were fitted with a larger sail, to house additional masts, and built 13 feet 9 inches longer than the other units of the class to include more SUBSAFE features, additional reserve buoyancy, more intelligence gathering equipment and improved accommodations. Haddock was completed with the larger sail but the standard 279-foot (85 m) hull.

The engine room of Jack was lengthened by 10 feet (3.0 m) to accommodate an experimental direct-drive propulsion system using concentric counter-rotating propellers. Although counter-rotating propellers produced impressive gains in speed on the experimental Albacore, in Jack the results were disappointing because of the difficulty in sealing the shaft. Jack was also used to test polymer ejection that could reduce flow noises that degraded sonar performance.^{[citation needed]}

Ships in class

The gaps in the hull number sequence were taken by the unique Tullibee, and the George Washington, Ethan Allen, and Lafayette-class fleet ballistic missile submarine classes.^{[citation needed]}