A VOR/DME ground station in Germany

In radio navigation, a VOR/DME is a radio beacon that combines a VHF omnidirectional range (VOR) with a distance-measuring equipment (DME).[1] The VOR allows the receiver to measure its bearing to or from the beacon, while the DME provides the slant distance between the receiver and the station. Together, the two measurements allow the receiver to compute a position fix.[2]

The VOR system was first introduced in the 1930s, but didn't enter significant commercial use until the early 1950s. It became much more practical with the introduction of low-cost solid state receivers in the 1960s. DME was a modification of World War II-era navigation systems like Gee-H, and began development in 1946. Like VOR, it only became practical with the introduction of solid state receivers during the 1960s.

VOR/DME symbol used on aeronautical charts

During the mid-1960s, ICAO began the process of introducing a standardized radio navigation system for medium-area coverage on the order of a few hundred kilometres. This system would replace the older Low-frequency radio range and similar systems used to navigate over national ranges. A number of proposals were submitted, including ones based solely on angle measurements like VOR, solely on distance measures like DME, combinations, or systems that output a location directly, like Decca Navigator and Loran-C.

VOR/DME eventually won the standardization effort, due to a number of factors. One was that the direct measurement systems like Loran were generally much more expensive to implement (and would be into the 1980s) while Decca had problems with static interference from lightning strikes because of its low 70 to 129 kHz frequency. The choice of VOR/DME as a hybrid was due largely to it being easier to measure and then plot on a map. With VOR/DME, measurement from a single station reveals an angle and range, which can be easily drawn on a chart. Using a system based on two angles, as an example, requires two measurements at different frequencies (or using two radios) and then the angles plotted from both on a single chart which may be difficult in a cramped cockpit.

Eventually, the FAA began to integrate their VOR/DME facilities with stations based on the TACAN standard, and the stations are called VORTAC.[3] Then, most aviation moved to GNSS and GPS satellite navigation, and only use these older systems as a backup.

References

  1. ^ Navigation Programs, Federal Aviation Administration AJM-32 (1986). VOR, VOR/DME, and Vortac Siting Criteria. Federal Aviation Administration. p. 2. Retrieved 28 September 2023.((cite book)): CS1 maint: numeric names: authors list (link)
  2. ^ steinmetz, George G.; Bowles, Roland L. (1984). Development of a VOR/DME Model for an Advanced Concepts Simulator (PDF). Hampton, VA: National Aeronautics and Space Administration. Retrieved 28 September 2023.
  3. ^ Federal Aviation Administration, Mission Support Services Policy (2023). Aeronautical Information Manual. Washington, D.C., U.S.A.: Federal Aviation Administration. pp. Chapter 1, Section 1. Retrieved 28 September 2023.
Category