Ju 288
Sole Ju 288A prototype (Ju 288V5) with Junkers Jumo 222 engines and ducted spinners
Role Medium bomber
National origin Germany
Manufacturer Junkers
First flight 29 November 1940
Number built 22
Developed from Junkers Ju 88
Junkers 288B (Ju 288 V13, DB 606 engines) prototype

The Junkers Ju 288, originally known within the Junkers firm as the EF 074, was a German bomber project designed during World War II, which only ever flew in prototype form. The first aircraft flew on 29 November 1940; 22 development aircraft were eventually produced.

The Ju 288 was the winner of the Bomber B contest, although the contest was started by the Junkers firm's submission of the EF 074 and their selection was never really in doubt. The Bomber B concept of a Schnellbomber was originally intended to replace the Junkers Ju 88. The Ju 288 offered a design that was larger, offered cabin pressurization for high altitude missions, had longer range, a much greater bomb payload, was even faster, and had improved defensive firepower. The design was intended to replace all the bombers then in Luftwaffe service.

Delivering all of these requirements in a single airframe demanded much more powerful engines; all of the Bomber B concepts, at one time or another, relied on the Junkers Jumo 222 engine to deliver this power. Ultimately, the Jumo 222 was a failure in spite of massive effort and several redesigns over a period of several years, with nearly 300 development prototypes produced. No suitable replacement was ever forthcoming, dooming the Ju 288 program, and leaving the Luftwaffe with older bomber designs during the second half of World War II.

Design and development

Prior to the opening of World War II, the Luftwaffe bomber force included three major types, the Dornier Do 17 and Ju 88, both classed as schnellbomber, and the slower but somewhat larger Heinkel He 111. Although the Ju 88 outperformed the other designs in service, it however possessed adverse characteristics, including its very small internal bomb bay that forced it to carry some of its load externally, degrading performance.

Junkers had been outlining a variety of improved models of the Ju 88 since 1937, powered by the planned Jumo 222 multibank engine, or Jumo 223 inline multibank diesel of greatly increased power meant to achieve a 2,000 horsepower (1,500 kW) output level, a serious challenge for Germany's aviation engine industry of the time. The EF 074 was essentially a scaled-up Ju 88, sharing its general layout and most of its fuselage and wings with extensions in various places. The nose was redesigned with a more streamlined "stepless cockpit", having no separate windscreen panels for the pilot and co-pilot. This layout allowed cabin pressurization to be more easily implemented. This design approach had been growing in favour, subsequently appearing in various German types, notably the He 111P and -H's.

All of the defensive armament was meant to be remotely controlled [1] comprising a remotely operated rear-facing dorsal turret at the rearmost end of the cockpit glazing, and two remotely operated "flank" turrets on the rearwards sides of the fuselage just forward of the empennage, otherwise each resembling the FDSL 131 units of the Me 210. The exclusive use of remotely operated turrets for the Ju 288's defensive firepower allowed them to be positioned more efficiently, as well as eliminating "breaks" in the fuselage pressurization.

The fuselage was expanded along its length to allow for a much longer bomb bay – somewhat as had been done with the Dornier Do 217 then in development itself – that would allow for a 3,630 kg (8,000 lb) payload to be carried internally, eliminating the need to carry ordnance on outside hardpoints.

Bomber B Competition

No serious work was undertaken on these versions, but after Heinrich Hertel left Heinkel and joined Junkers in 1939, the EF 074 design was submitted to the RLM in May 1939. Accordingly, the RLM sent out the specifications for the Bomber B design competition in July, the Ju 88 retroactively becoming the second aircraft to be designated Bomber A, as the 3 June 1936 specification for the He 177 also had that name. The Bomber B program aimed at replacing all of the medium bombers in the Luftwaffe inventory with a new design based on the EF.74 or something with equal performance. Bomber B was intended to have even better speed than the Ju 88, high-altitude cruising with a pressurized cockpit, heavier defensive armament, range allowing it to cover any point in the British Isles, and a 4,000 kg (8,820 lb) warload, double that of the earlier generation bombers. A number of companies returned proposals, but these were to some extent a formality, the EF.74 had already been selected as the winner, and of the rest of the designs submitted, only the Focke-Wulf Fw 191 and Dornier Do 317 progressed even as far as prototypes, and the Henschel Hs 130 coming under consideration as a late entrant.

Work began on building prototypes soon after, and the first example was completed by mid-1940. Power was supposed to be supplied by two 24-cylinder Jumo 222 six-bank, four cylinders per bank, over-1,500 kW output class powerplants, but problems with the Jumo 222's development – as with almost every new concept for over-1,500 kW output, reciprocating aircraft engines then underway in the Third Reich – meant the first prototypes flew with BMW 801 radial engines, instead. The first flight-quality 222s did not arrive until October 1941, and even then it was clear they were nowhere near ready for full-scale production. When it became apparent the 222 was not likely to become a viable powerplant, in May 1942, Junkers proposed replacing them, for their projected Ju 288C version, with the much heavier Daimler Benz DB 606s instead; the same 1.5 tonne, twin-crankcase "welded-together engines" that Reichsmarschall Hermann Göring complained about some three months later, regarding the He 177's own endless powerplant troubles.

Undercarriage difficulties

Ju 288 V1 prototype with twin BMW 801 engines. Is it being held in flying attitude by a support under the tail. The actuator rods for the landing gear's oleo struts are visible behind the main struts.

The Ju 288's intricate main landing gear system's design proved to be troublesome, possessing twin vertical members comprising the main "Y-shaped" retraction strut unit, directly behind a single oleo strut,[2] for each pair of twinned wheels mounted through a forward-projecting lever-action arm, to the lower end of the uniquely attached main oleo strut unit. This single-tube oleo strut was pivoted off the lower end of the twin-member, "Y-shaped" retraction strut unit, and was rotated in the vertical plane about this single attachment in a rearwards direction during retraction of the main-gear unit, separate from the twin-member unit to help "shorten" its stowed length within the engine nacelle.

This distinctive type of design required the oleo strut's freely moving top end to physically rotate downwards and aftwards during the rear-swinging retraction of the main "Y-shaped" member, operated by a lever and gear-sector system mounted on the portside of each main gear assembly, operated with a long lever that had its upper end pivoted from a fixed bracket, anchored to the firewall's rear surface.[3] The lever/sector gear system swiveled the oleo strut about its attachment point during the retract cycle, through an arc of roughly 180º from its position when the main gear was fully extended. The stowed position of the oleo strut ended up orienting it aftwards within the rear of the engine nacelle, and placing the wheels' axle location just ahead of and above the oleo strut's pivot point when fully retracted.[4]

Such a complex main gear design, with only the single pivoting retraction point for its oleo struts taking the primary stress of touchdown, was likely only one of the many potential sources of trouble causing the Ju 288's main gear units to repeatedly collapse on touchdown.[5]

Operational history

Although the 288 never even reached production status, let alone official operational service, the aircraft did see limited combat duty.[citation needed] In 1944, following the cancellation of the 288 program, the surviving A and C series prototypes were hurriedly fitted with defensive armament and equipment and deployed as reconnaissance bombers on the Western Front. Very few missions were flown, owing to the scarcity of aviation fuel, spare parts and the unresolved problems with the aircraft's powerplant and undercarriage. It is believed[by whom?] that the 288s were attached to the same unit operating the small number of Ju 388 reconnaissance planes that saw service.


Specifications (Ju 288C-1)

Data from Junkers aircraft and engines, 1913-1945,[6] German aircraft of the Second World War[7]

General characteristics



See also

Related development

Aircraft of comparable role, configuration, and era

Related lists


  1. ^ in one proposal Archived 13 April 2014 at the Wayback Machine
  2. ^ "Archive photo of Ju 288 starboard main landing gear". Archived from the original on 13 April 2014. Retrieved 11 July 2014.
  3. ^ Junkers Ju 288 (Bomber B) (YouTube) (YouTube). History of the Third Reich. Event occurs at 1:28 to 1:33. Retrieved 18 November 2016.
  4. ^ Animation of Ju 288 maingear retraction cycle
  5. ^ Sengfelder, Günther (1993). German Aircraft Landing Gear. Atglen, PA USA: Schiffer Publishing. pp. 175–177. ISBN 0-88740-470-7. The Ju 288's landing gear was most innovative in its design. A Y-shaped bearer was mounted in the engine nacelle with its upper arms hinged. At the bottom end of this bearer was the shock absorber leg, which was likewise hinged. Two double-brake wheels, with (metric) size 1015 x 380 tires, were mounted on the cross-axle. During the retraction cycle a folding strut was raised by a hydraulic jack. The bottom part of the folding strut drew the Y-bearer upwards. Functioning via a lever-and-gear arrangement, a pushrod positioned parallel to the Y-bearer acted upon another gear segment mounted to the oleo leg's hinge pin and rotated it about this as the Y-bearer was drawn upwards.
  6. ^ Kay, Anthony L. (2004). Junkers aircraft and engines, 1913-1945 (1st ed.). London: Putnam Aeronautical Books. pp. 190–197. ISBN 0851779859.
  7. ^ Smith, J.R.; Kay, Anthony L. (1990). German aircraft of the Second World War (7th impression ed.). London: Putnam. pp. 211–2202. ISBN 0851778364.


  • Hitchcock, Thomas H. Junkers 288 (Monogram Close-Up 2). Acton, MA: Monogram Aviation Publications, 1974. ISBN 0-914144-02-2.